K51

K51 - Pneumatic Rod Seal
   KASTAŞ NO d (f9) D (H10) b B (-0/+0,5) B1 (-0/+0,2) D1 (±0,1) r c
 K51-008 8 14 7 12 5.4 15.6 0.8 1.2
 K51-010 10 16 7 12 5.4 17.6 0.8 1.2
 K51-012 12 22 10,4 13 7,7 24,2 1,1 1,5
 K51-012/1 12 20 10,4 13 7,7 22,2 1,1 1,5
 K51-016 16 26 10,4 13 7,7 28,2 1,1 1,5
 K51-018 18 28 10,4 13 7,7 30,2 1,1 1,5
 K51-018/1 18 26 10,4 13 7,7 28,2 1,1 1,5
 K51-020 20 30 10,4 13 7,7 32,2 1,1 1,5
 K51-022 22 32 10.4 13 8 34.8 1.4 2
 K51-025 25 35 10,4 13 8 37,8 1,4 2
 K51-030 30 40 11,2 14 8 42,8 1,4 2
 K51-032 32 42 10,4 13 8 44,8 1,4 2
 K51-040 40 50 10,4 13 8 52,8 1,4 2
 K51-045 45 55 10,4 13 8,6 58,6 1,8 2
 K51-050 50 60 10,4 13 8,6 63,6 1,8 2

K51 is a single acting pneumatic rod seal specially designed not to require additional element for axial fitting within the housing.

PRODUCT ADVANTAGES
• Superior sealing effect
• Minimal space requirement
• Easy installation to open grooves
• Wide range of dimensions
• Economical sealing solution
• Highly wear resistant

APPLICATION
Pneumatic cylinders.
MATERIAL   CODE
PU 92 SHORE A  PU9201
OPERATING CONDITIONS
MEDIA Prepared , dried and de-oiled compressed air
TEMPERATURE -30°C +80 °C
PRESSURE ≤16 Bar
SPEED ≤1.0 m/sn
Note: The above data are maximum values and cannot be used at the same time.

   

SURFACE ROUGHNESS Rmax
Sliding Surface Ød ≤4 μm
Groove Base ØD ≤10 μm
Groove Flanks ≤15 μm

INSTALLATION
It can be assembled into closed groove with tight hand force. K51 does not need additional element such as circlip for axial fitting within the housing. We recommend using special assembly tool. It is very important that the assembly tools must be of soft material and have no sharp edges. Before installation the sealing element must be oiled with system oil.